SIP User's Manual 142 Document #: LTRT-65412
MP-11x & MP-124
3.3.4.9 Endpoint Settings
The Endpoint Settings submenu allows you to configure analog (FXS/FXO) port-specific
parameters. This submenu includes the following page items:
îš„ Authentication (refer to ''Configuring Authentication'' on page 142)
îš„ Automatic Di
aling (refer to ''Configuring Automatic Dialing'' on page 143)
îš„ Calle
r Display Information (refer to ''Configuring Caller Display Information'' on page
144)
îš„ Call Fo
rward (refer to ''Configuring Call Forward'' on page 146)
îš„ Calle
r ID Permissions (refer to ''Configuring Caller ID Permissions'' on page 147)
îš„ Call Waiting (refer to ''
Configuring Call Waiting'' on page 148)
3.3.4.9.1 Configuring Authentication
The 'Authentication' page defines a user name and password for authenticating each
device port. Authentication is typically used for FXS interfaces, but can also be used for
FXO interfaces.
Notes:
• The 'Authentication Mode' parameter (configured in ''Configuring Proxy
and Registration Parameters'' on page 94) determines whether
authentication is performed per port or for the entire device. If
authentication is performed for the entire device, the configuration in the
'Authentication' page is ignored.
• If either the user name or password field is omitted, the port's phone
number (defined in Configuring the Endpoint Phone Numbers on page
149) and global password (refer to the parameter 'Password' described in
''Configuring Proxy and Registration Parameters'' on page 94) are used
instead.
• You can also configure Authentication using the ini file table parameter
Authentication (refer to ''SIP Configuration Parameters'' on page 252).
To Next Page
Loading...
Need help?
General
