SIP User's Manual 238 Document #: LTRT-65412
MP-11x & MP-124
6.3.6 BootP Parameters
The BootP parameters are described in the table below. The BootP parameters are special
'hidden' parameters. Once defined and saved in the device's flash memory, they are used
even if they don't appear in the ini file.
Table 6-19: BootP Parameters
Parameter Description
[BootPRetries]
Note: For this parameter to take effect, a device reset is required.
This parameter is used to:
Set the number of BootP requests
the device sends during start-up.
The device stops sending BootP
requests when either BootP reply
is received or number of retries is
reached.
 [1] = 1 BootP retry, 1 sec.
 [2] = 2 BootP retries, 3 sec.
 [3] = 3 BootP retries, 6 sec.
(default).
 [4] = 10 BootP retries, 30 sec.
 [5] = 20 BootP retries, 60 sec.
 [6] = 40 BootP retries, 120 sec.
 [7] = 100 BootP retries, 300
sec.
 [15] = BootP retries
indefinitely.
Set the number of DHCP packets
the device sends. If after all
packets are sent there's still no
reply, the device loads from flash.
 [1] = 4 DHCP packets
 [2] = 5 DHCP packets
 [3] = 6 DHCP packets (default)
 [4] = 7 DHCP packets
 [5] = 8 DHCP packets
 [6] = 9 DHCP packets
 [7] = 10 DHCP packets
 [15] = 18 DHCP packets
[BootPSelectiveEnable]
Enables the Selective BootP mechanism.
 [1] = Enabled.
 [0] = Disabled (default).
The Selective BootP mechanism (available from Boot version 1.92)
enables the device's integral BootP client to filter unsolicited
BootP/DHCP replies (accepts only BootP replies that contain the text
'AUDC' in the vendor specific information field). This option is useful in
environments where enterprise BootP/DHCP servers provide undesired
responses to the device's BootP requests.
Notes:
 For this parameter to take effect, a device reset is required.
 When working with DHCP (i.e., the parameter DHCPEnable is set to
1), the selective BootP feature must be disabled.
To Next Page
Loading...
Need help?
General
