Version 5.8 245 September 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
If the SubjectAltName is not marked as ‘critical’ and there is no
match, the CN value of the SubjectName field is compared with
the parameter TLSRemoteSubjectName. If a match is found,
the connection is established. Otherwise, the connection is
terminated.
Web: TLS Client Verify Server
Certificate
EMS: Verify Server Certificate
[VerifyServerCertificate]
Determines whether the device, when acting as client for TLS
connections, verifies the Server certificate. The certificate is
verified with the Root CA information.
 [0] Disable (default).
 [1] Enable.
Note: If Subject Name verification is necessary, the parameter
PeerHostNameVerificationMode must be used as well.
Web/EMS: TLS Remote Subject
Name
[TLSRemoteSubjectName]
Defines the Subject Name that is compared with the name
defined in the remote side certificate when establishing TLS
connections.
If the SubjectAltName of the received certificate is not equal to
any of the defined Proxies Host names/IP addresses and is not
marked as 'critical', the Common Name (CN) of the Subject
field is compared with this value. If not equal, the TLS
connection is not established. If the CN uses a domain name,
the certificate can also use wildcards (‘*’) to replace parts of the
domain name.
The valid range is a string of up to 49 characters.
Note: This parameter is applicable only if the parameter
PeerHostNameVerificationMode is set to 1 or 2.
6.4.5 SSH Parameters
The Secure Shell (SSH) parameters are described in the table below.
Table 6-24: SSH Parameters
Parameter Description
[SSHAdminKey]
Determines the RSA public key for strong authentication to logging in to
the Secure Shell (SSH) interface (if enabled).
The value should be a base64-encoded string. The value can be a
maximum length of 511 characters.
For additional information, refer to the Product Reference Manual.
[SSHRequirePublicKey]
Enables or disables RSA public keys for SSH.
 [0] = RSA public keys are optional, if a value is configured for the ini
file parameter SSHAdminKey (default).
 [1] = RSA public keys are mandatory.
To Next Page
Loading...
Need help?
General
