Version 5.8 285 September 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
easily identify them later.
 To use the settings of the corresponding global parameter, enter the
value -1.
 To apply default settings to a parameter, enter two adjacent dollar signs
($$).
 For a detailed description of each parameter, refer to its corresponding
"global" parameter.
 For a description of using ini file table parameters, refer to ''Format of ini
File Table Parameters'' on page 191.
6.7.4 Voice Mail Parameters
The voice mail parameters are described in the table below. For detailed information on the
Voice Mail application, refer to the CPE Configuration Guide for Voice Mail.
Note: Voice Mail is applicable only to FXO interfaces.
Table 6-32: Voice Mail Parameters
Parameter Description
Voice Mail Interface
[VoiceMailInterface]
Enables the device's Voice Mail application and determines the
communication method used between the PBX and the device.
 [0] None (default)
 [1] DTMF
 [2] SMDI
Notes:
 To enable voice mail per Hunt Group, you can use a Tel Profile ID
that is configured with voice mail interface enabled. This eliminates
the phenomenon of call delay on lines not implementing voice mail
when voice mail is enabled using this global parameter.
 For detailed information on voice mail configuration, refer to the
CPE Voice Mail Configuration Guide.
Line Transfer Mode
[LineTransferMode]
Determines the call transfer method used by the device.
 [0] None = IP (default).
 [1] Blind = PBX blind transfer. After receiving a REFER message
from the IP side, the FXO sends a hook-flash to the PBX, dials the
digits (that are received in the Refer-To header), and then
immediately drops the line (on-hook). The PBX performs the
transfer internally.
 [2] Semi Supervised = PBX Semi-Supervised transfer. After
receiving a REFER message from the IP side, the FXO sends a
hook-flash to the PBX, and then dials the digits (that are received
in the Refer-To header). If no Busy or Reorder tones are detected
(within approximately 2 seconds), the device completes the call
To Next Page
Loading...
Need help?
General
