EasyManuals Logo
Home>AudioCodes>Gateway>MP-124

AudioCodes MP-124 User Manual

AudioCodes MP-124
486 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #328 background imageLoading...
Page #328 background image
SIP User's Manual 328 Document #: LTRT-65412
MP-11x & MP-124
Parameter Description
Guard Time Between Calls
[GuardTimeBetweenCalls]
Defines the time interval (in seconds) after a call has ended and a new
call can be accepted for IP-to-Tel (FXO) calls.
The valid range is 0 to 10. The default value is 1.
Notes:
 Occasionally, after a call ends and on-hook is applied, a delay is
required before placing a new call (and performing off-hook). This is
necessary to prevent incorrect hook-flash detection or other glare
phenomena.
 This parameter is applicable only to FXO interfaces.
6.14 Number Manipulation and Routing Parameters
This subsection describes the device's number manipulation and routing parameters.
6.14.1 Routing Parameters
The routing parameters are described in the table below.
Table 6-52: Routing Parameters
Parameter Description
Endpoint Phone Number Table
Endpoint Phone Number Table
[TrunkGroup]
This ini file table parameter is used to define and activate the
device's endpoints, define telephone numbers for them, and
assign them to Hunt Group IDs. The format of this parameter is
shown below:
[TrunkGroup]
FORMAT TrunkGroup_Index = TrunkGroup_TrunkGroupNum,
TrunkGroup_FirstTrunkId, TrunkGroup_FirstBChannel,
TrunkGroup_LastBChannel, TrunkGroup_FirstPhoneNumber,
TrunkGroup_ProfileId, TrunkGroup_LastTrunkId,
TrunkGroup_Module;
[\TrunkGroup]
For example:
TrunkGroup 0 = 1, 0, 0, 1, 4, 101, 0, 1; (Hunt Group ID 1,
channels 1-4, phone number 101 for Channel 1)
TrunkGroup 1 = 1, 0, 0, 5, 8, 201, 0, 0; (Hunt Group ID 1,
channels 5-8, phone number 201 for Channel 5)
Notes:
 The first entry in this table starts at index 0.
 Each endpoint (i.e., channel) must be assigned a unique
phone number. In other words, no two endpoints can have
the same phone number.
 The parameters TrunkGroup_FirstTrunkId,
TrunkGroup_LastTrunkId, and TrunkGroup_Module are not
applicable.
 For configuring this table in the Web interface, refer to
Configuring the Endpoint Phone Numbers on page 149 .

Table of Contents

Other manuals for AudioCodes MP-124

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AudioCodes MP-124 and is the answer not in the manual?

AudioCodes MP-124 Specifications

General IconGeneral
BrandAudioCodes
ModelMP-124
CategoryGateway
LanguageEnglish

Related product manuals