Oversize
Specifies whether margins are within or outside the HP-GL/2 data image drawing range.
Display this item by selecting the following.
(Setup) > Printer settings > Print settings > HP-GL/2 print settings > Paper settings
• Enable•
Specifies margins outside the HP-GL/2 data image drawing range.
Adding margins outside the image drawing range will not cause part of the image to be cut off.
However, you will need to print on paper of a size that is greater than the size of the image drawing
range specified by the HP-GL/2 data plus the top, bottom, left, and right margins.
• Disable•
Specifies margins inside the HP-GL/2 data image drawing range.
Depending on the layout, adding margins inside the image drawing range may cause part of the image
to be cut off.
Note
• Some CAD applications can cause the origin to be out of position and part of the image to be cut
off. Experiment with the Disable and Enable settings of this function to find the one that works
best.
OVERSIZE SETTING EXAMPLES
A. Printed page size
B. Image drawing range
When you print an image above, using Oversize allows you to select where to apply margins (outside/
inside the image) based on the image drawing range.
Select Enable to apply margins outside the image, or select Disable to apply those inside.
• When Disable is selected:•
Printing is performed based on the image drawing range. The origin is specified on the upper left of
the paper.
386
To Next Page
Loading...
Need help?
General