Generating Server Certificate
When you use SSL connection via IPv6 network, you need to generate an IPv6 server certificate using the
printer.
Generate the server certificate from Remote UI.
Follow the procedure below.
1. Checking Printer's IP Address1.
2. Generating Server Certificate2.
3. Checking Generated Server Certificate3.
Important
• If you generate an IPv6 server certificate, a warning message may appear if you are using Remote UI.•
To reset the IPv6 server certificate, select Security > TLS server settings > Delete key and
certificate in this order, and select OK on the displayed screen.
Checking Printer's IP Address
1. Select (Network) on the HOME screen.1.
2.
Select the enabled LAN.
2.
Diagonal lines are displayed for disabled LAN icons.
3. Check the value on IPv6 link-local address.3.
Write down the value on IPv6 link-local address for your reference when you generate a server
certificate.
Generating Server Certificate
1.
Start up Remote UI.
1.
Start up Remote UI
2.
Select Security.
2.
3.
Select TLS server settings.
3.
4.
Select Generate key and certificate.
4.
5.
Select Generate self-signed cert.
5.
6.
Specify each setting item.
6.
470
To Next Page
Loading...
Need help?
General