Cisco 7941G Administration Guide

SIP General Configuration Menu
The SIP General Configuration menu displays information about the configurable SIP parameters on the
phone. The following table describes the options in this menu.
Table 15: SIP General Configuration Menu Options
To ChangeDescriptionOption
Display only. Cannot configure.Displays the CODEC to use when a call is
initiated. This value will always be set to
none.
Preferred CODEC
Display only. Cannot configure.Displays the configuration of the
out-of-band signaling for tone detection on
the IP side of a gateway. The Cisco Unified
IP Phone (SIP) supports out-of-band
signaling by using the AVT tone method.
This value will always be set to avt.
Out of Band DTMF
Display only. Cannot configure.This value will always be set to Yes.Register with Proxy
From Cisco Unified Communications
Manager Administration, choose Device
> Device Settings > SIP Profile.
Displays the amount of time, in seconds,
after which a registration request expires.
Register Expires
Display only. Cannot configure.Displays the text that is displayed on the
top right status line of the LCD on the
phone. This text is for end user display only
and has no effect on caller identification or
messaging. This value will always be set to
null.
Phone Label
From Cisco Unified Communications
Manager Administration, choose Device
> Device Settings > SIP Profile.
This value is set to No by default.Enable VAD
From Cisco Unified Communications
Manager Administration, choose Device
> Device Settings > SIP Profile.
Displays the start Real-Time Transport
Protocol (RTP) range for media.
Start Media Port
From Cisco Unified Communications
Manager Administration, choose Device
> Device Settings > SIP Profile.
Displays the end Real-Time Transport
Protocol (RTP) range for media.
End Media Port
Display only. Cannot configure.Displays if Network Address Translation
(NAT) is enabled. This value will always
be set to false.
NAT Enabled
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco
Unified Communications Manager 9.0 (SCCP and SIP)
86
Cisco Unified IP Phone Settings
SIP Configuration Menu for SIP Phones

Cisco 7941G Specifications

General

Keypad number of keys	12
Touchscreen	-
Display resolution	320 x 222 pixels
Speakerphone	Yes
Voice codecs	G.729a
Bluetooth	No
Supported network protocols	DHCP, TFTP, SCCP, DSCP
Ethernet LAN (RJ-45) ports	2
Input voltage	48 V
Dimensions (WxDxH)	266.7 x 152.4 x 203.2 mm
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Handset type	Wired handset
Product type	IP Phone
Product color	Gray
Safety	(UL) 60950, (CSA) C22.2 No. 60950, IEC 60950, EN 60950, AS/NZS 60950
Certification	CE (FCC) 15 (CFR 47) B ICES-003 B EN55022 B CISPR22 B AS/NZ 3548 B VCCI B EN55024 EN 50082-1 EN 61000-3-2 EN 61000-3-3
Compliance industry standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1Q, IEEE 802.3af
Lines quantity	- lines
Phonebook capacity	- entries
Number of handles included	1 pc(s)

Weight and Dimensions

Weight	1600 g