Cisco 7941G Administration Guide

DescriptionField
This check box determines if you will allow the EnergyWise domain
controller policy to send power level updates to the phones. The
following conditions apply:
1
If the phone is in full power save mode and the level is set to any
standby level, the phone will go to Power Save when idle and
remain in that mode until the next Cisco Unified CM scheduled
power level change or user interaction.
2
If the phone is in Power Save or at full power and the level is set
to any nonoperational level, the phone will power down when idle
and remain powered off until the switch reapplies power or the
user wakes the phone.
For example, assume the Phone Off Time is set to 22:00 (10:00 p.m.),
the value in the Phone On Time field is 06:00 (6:00 a.m.), and the
Enable Power Save Plus has one or more days selected.
•
If EnergyWise directs the phone to turn off at 20:00 (8:00 p.m.),
then the directive remains in effect until the configured Phone
On Time at 6:00 a.m., assuming no phone user intervention
occurs.
•
At 6 a.m., the phone will turn on and resume receiving its power
level changes from the settings in Cisco Unified Communications
Manager Administration.
•
To change the power level on the phone again, EnergyWise must
reissue a new power level change command.
To disable Power Save Plus, you must uncheck the
Allow EnergyWise Overrides check box. Leaving the
Allow EnergyWise Overrides checked with no days
selected in the Enable Power Save Plus field does not
disable Power Save Plus.
Note
Allow EnergyWise Overrides
UCR 2008 Setup
The parameters that support UCR 2008 reside in Cisco Unified Communications Manager Administration.
The following table describes the parameters and indicates the procedure to change the setting.
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco
Unified Communications Manager 9.0 (SCCP and SIP)
156
Features, Templates, Services, and Users
UCR 2008 Setup

Cisco 7941G Specifications

General

Keypad number of keys	12
Touchscreen	-
Display resolution	320 x 222 pixels
Speakerphone	Yes
Voice codecs	G.729a
Bluetooth	No
Supported network protocols	DHCP, TFTP, SCCP, DSCP
Ethernet LAN (RJ-45) ports	2
Input voltage	48 V
Dimensions (WxDxH)	266.7 x 152.4 x 203.2 mm
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Handset type	Wired handset
Product type	IP Phone
Product color	Gray
Safety	(UL) 60950, (CSA) C22.2 No. 60950, IEC 60950, EN 60950, AS/NZS 60950
Certification	CE (FCC) 15 (CFR 47) B ICES-003 B EN55022 B CISPR22 B AS/NZ 3548 B VCCI B EN55024 EN 50082-1 EN 61000-3-2 EN 61000-3-3
Compliance industry standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1Q, IEEE 802.3af
Lines quantity	- lines
Phonebook capacity	- entries
Number of handles included	1 pc(s)

Weight and Dimensions

Weight	1600 g