Table 23: Ethernet Configuration Menu Option
To ChangeDescriptionOption
From Cisco Unified Communications
Manager Administration, choose
Device > Phone > Phone
Configuration.
Indicates whether the internal switch
begins forwarding packets between the
PC port and switched port on the phone
when the phone becomes active.
•
When forwarding delay is set to
disabled, the internal switch
begins forwarding packets
immediately.
•
When forwarding delay is set to
enabled, the internal switch waits
eight seconds before forwarding
packets between the PC port and
the switch port.
Default is disabled.
Forwarding Delay
From Cisco Unified Communications
Manager Administration, choose
Device > Phone > Phone
Configuration.
Indicates whether the phone will
forward packets transmitted and
received on the network port to the
access port.
Enable this option if an application that
requires monitoring of the phone’s
traffic is being run on the access port.
These applications include monitoring
and recording applications common in
call center environments and network
packet capture tools that are used for
diagnostic purposes.
Span to PC Port
Security Configuration Menu
The Security Configuration that you access directly from the Settings menu provides information about various
security settings. It also provides access to the Trust List menu. The Trust List menu indicates if the CTL or
ITL files are installed on the phone.
The phone also has a Security Configuration menu that you access directly from the Settings menu. For
information about the security options on that menu, see Security Configuration Menu, on page 108.
Note
The following table describes the options on the Security Configuration menu.
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
99
Cisco Unified IP Phone Settings
Security Configuration Menu