Speakerphone
By default, the wideband-capable speakerphone is enabled on the Cisco Unified IP Phone.
Disable Speakerphone
To disable the speakerphone using Cisco Unified CM Administration, perform the following procedure:
Procedure
Step 1
Choose Device > Phone and locate the phone you want to modify.
Step 2
In the Phone Configuration window, check Disable Speakerphone.
Step 3
Click Apply.
Headset
Although Cisco Systems performs internal testing of third-party headsets for use with the Cisco Unified IP
Phones, Cisco does not certify or support products from headset or handset vendors.
We recommend that the use of good quality external devices, for example, headsets that are screened against
unwanted radio frequency (RF) and audio frequency (AF) signals. Depending on the quality of headsets and
their proximity to other devices such as cell phones and two-way radios, some audio noise or echo may still
occur. An audible hum or buzz may be heard by either the remote party or by both the remote party and the
Cisco Unified IP Phone user. Humming or buzzing sounds can be caused by a range of outside sources; for
example, electric lights, electric motors, or large PC monitors. See External Device Use, on page 48 for more
information.
In some cases, hum can be reduced or eliminated by using a local power cube or power injector.Note
These environmental and hardware inconsistencies in the locations where Cisco Unified IP Phones are deployed
means that there is not a single headset solution that is optimal for all environments.
We recommend that customers test headsets in their intended environment to determine performance before
making a purchasing decision and deploying en masse.
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco
Unified Communications Manager 9.0 (SCCP and SIP)
46
Cisco Unified IP Phones Installation
Speakerphone
To Next Page
Loading...
Need help?
General
Weight and Dimensions
