Epygi QX200 Administrator's Guide

QX50/QX200/QX2000; (SW Version 6.0.x) 115
QX50/QX200/QX2000 Manual II: Administrator’s Guide
For
FXS
lines:
Transmit Gain defines the phone speaker volume on the call.
Receive Gain defines the volume of the phone microphone on
the call.
For FXO lines:
Transmit Gain defines the level of voice transmitted from QX IP
PBX to the FXO network.
Receive Gain defines the volume of voice received by QX IP PBX
from the FXO network.
For Voice Mail:
Recording Gain defines the volume of the phone microphone
upon playing voice mails or system messages.
Playback Gain defines the phone speaker volume upon playing
voice mails or system messages.
For Audio Lines:
Transmit Gain (Line Out) defines the level
of voice
transmitted from QX IP PBX to the Audio Line Out port.
Receive Gain (Line In) defines the volume of voice received
by QX IP PBX from the Audio Line In port.
The
Restore Default Gains
button restores the default values.
Fig.II- 172: Gain Control page
3PCC Settings
The
3PCC Settings
page is used to adjust the third party call
controlling settings. 3PCC service on the QX IP PBX allows call
controlling applications to remotely initiate and handle calls on
the QX IP PBX and to subscribe for certain event notifications
from the QX IP PBX.
This page consists of the following components:
The Secure Connection checkbox is used enable a secure
encrypted connection between the call controlling application
and the QX IP PBX.
Fig.II- 173: 3PCC Settings page
Please Note: For successful connection, this option should be set up in the same way on both sides (enabled or disabled on both sides).
The Request Timeout text field requires the timeout (in seconds) during which the QX IP PBX should receive a response to the request from the call
controlling application. If the response is not received during this timeout, QX IP PBX will perform a request dependent default action. For example, if the
call controlling application is configured to handle incoming calls on the QX IP PBX. Once the incoming call occurs, QX IP PBX is trying to transfer the call to
the call controlling application. If the call controlling application does not response within the mentioned timeout, QX IP PBX will answer the call or
perform an action configured for unanswered incoming calls. This setting is dependent on the network conditions therefore consult with your network
administrator before changing the default value.
The read-only Feature Key text field indicates whether the feature key for the 3PCC Support is installed on the system. The system will not accept
connections from 3PCC applications if no key is found. The 3PCC support is an optional feature and can be activated with a feature key from the
Feature
Keys page.
The read-only WAN Port text field indicates whether there is a filtering rule specified for the
Call Control Access. If a third-party call control application
connects to the QX IP PBX from the WAN interface, a filtering rule for the corresponding host should be created on the
Call Control Access page to allow
the application a remote access. Creating a filtering rule is not required if the firewall is not setup on the QX IP PBX. The field shows Opened if there is at
least one enabled filtering rule for the
Call Control Access.
RADIUS Client Settings
RADIUS (Remote Authentication Dial In User Service) specifies the RADIUS protocol used for authentication, authorization and accounting, to
differentiate, to secure and to account for the users. The RADIUS Server provides the option for a caller from/through QX IP PBX to pass authentication
and to be able to dial a specific number.

Epygi QX200 Specifications

General

Brand	Epygi
Model	QX200
Category	Network Hardware
Language	English