Epygi QX200 Administrator's Guide

QX50/QX200/QX2000; (SW Version 6.0.x) 9
QX50/QX200/QX2000 Manual II: Administrator’s Guide
QX IP PBX’s Graphical Interface
Dashboard – Administrator’s Main Page
When the administrator logs in, the Epygi QX Management page is displayed with a table of active calls (including information about call peers, call
duration and start time) at the startup. The number of total active calls is displayed below the table.
The button Terminate next to each active call is used to terminate the corresponding call.
The Start Recording button next to each active call (except for calls to Auto Attendant) is used to manually start the recording of the corresponding call.
Once the call recording is started, the button changes to Stop now used to manually stop the call recording. The call recording can be restarted again if
needed.
The following main menus are available on Epygi QX50/QX200/QX2000: Setup, Extensions, Interfaces, Telephony, Firewall, Network, Status and
Maintenance. By clicking on menus the administrator may access the settings in each respective category and perform actions specific to each category.
The following menus may additionally occur when pressing to the PBX or Conference extensions:
• Your Extension (see Manual III: Extension User’s Guide)
• Conference
The Return link is used to return to the Epygi QX50/QX200/QX2000 Management page.
Fig.II- 1: Epygi QX IP PBX Management page
The functional button Renew Wan IP Address appears on the administrator’s main QX IP PBX Management page if the QX IP PBX device acts as a DHCP
client. The Renew WAN IP Address button is used to obtain a new WAN IP address in case, e.g., the QX IP PBX moves to another network.
The button Pending Events will be displayed in the upper right corner of the Administrator’s Main Menu page. Clicking on the button will lead to the
Events page that can be also accessed from the
Status Menu.
Language selection is available only when the custom Language Pack has been uploaded and it is used to enable custom language for QX GUI or returning
back to the default language - English.
The list of Users currently logged in is seen in the lower right corner of the Administrator's Main Menu. Information about IP address user accessed QX
IP PBX GUI from, the username user is logged in and the time until the next automatically logout is provided herein. The current version of the QX IP PBX's
firmware and of its boot loader is also available here. The idle session timeout is set to 20 minutes. If no action is performed during that time, user will be
automatically moved to the Login page and will be requested to login again.
Log Out is used to close the session between the user PC and QX and to leave the QX Web Management or to enter the management with another login.

Epygi QX200 Specifications

General

Brand	Epygi
Model	QX200
Category	Network Hardware
Language	English