Epygi QX200 Administrator's Guide

QX50/QX200/QX2000; (SW Version 6.0.x) 171
QX50/QX200/QX2000 Manual II: Administrator’s Guide
Automatic Firmware Update
The Automatic Firmware Update page allows you to configure an automatic update of the QX IP PBX’s firmware (software image) as it becomes available
on the server. When this service is enabled, on the configured day and time QX IP PBX will automatically check for a new available firmware on the server
and will either notify the administrator or update the firmware right away, depending on the configured settings.
The server configuration can be done manually.
Please Note: Independent on the selected server type, there should be an “auto-update” folder in the root directory of the server. QX IP PBX will check for
any new firmware in that specific folder only. Besides the firmware *.bin file, the “auto-update” folder should contain supplementary file(s) to point to the
correct firmware file.
The detailed instructions on the functionality of automatic firmware update as well as server configuration are described in the “Automatic Firmware
Update” document which you can find at the Epygi Web support portal.
This page consists of the following components:
The Enable Automatically Firmware Update checkbox selection enables the automatic firmware update service on the QX IP PBX.
The Server Name (the IP address or hostname), the Server Port
and the
Update Method
should be defined. The
Update Method
drop down list provides a possibility to choose among FTP, HTTP
or HTTPS methods. For some of these selections, authentication
Username and Password can be entered.
Please Note: In order to use Epygi’s public ftp server leave the
Server Name, Server Port, Update Method, User Name and
Password text fields to their default values (ftp.epygi.com, 21, ftp
and anonymous respectively, use blank for password).
Check for updates options allow you to select the frequency of
checking for a new update.
Check and notify – choose this selection if you only wish to
be notified about the new available firmware on the
server. With this selection, on the indicated weekday
and time, on daily or weekly basis, the QX IP PBX will
check for a new firmware available on the server. The
way of notification is configured from the
Events page.
Check and update – choose this selection to check and
automatically install the new firmware on the QX IP PBX
as it becomes available on the server. With this selection,
on the indicated weekday and time, on daily or weekly
basis, the QX IP PBX will check for a new firmware
available on the server, will automatically download and
install it on the QX IP PBX.
Fig.II- 290: Automatic Firmware Update page
The Check/Update Now button is used to manually initiate Check and notify or Check and update actions. The action to be executed depends on the
options selected above.
Reboot
The
Yes, Reboot Device
button is used to reboot the QX IP
PBX. Please note that the session with the QX IP PBX will be
closed, i.e., the QX IP PBX
GUI should be newly opened and a
new login will be required afterwards.
Fig.II- 291: Reboot device page

Epygi QX200 Specifications

General

Brand	Epygi
Model	QX200
Category	Network Hardware
Language	English