QX50/QX200/QX2000; (SW Version 6.0.x) 122
QX50/QX200/QX2000 Manual II: Administrator’s Guide
SIP Access
SIP Access
is used to allow or deny the SIP access to or from the
particular SIP servers, SIP hosts or a group of them. The
SIP Access
filtering rule may prevent or allow incoming or outgoing SIP calls to
or from specified SIP server(s) or host(s).
Fig.II- 187: Filtering Rules page
Blocked IPs
Blocked IP List
is used, traffic from specific hosts may be
blocked, no matter what services are opened in the other filters. NO
traffic will be allowed to the specified hosts. The Blocked IP List
service has a higher priority if the same host is also listed in the
Allowed IP List table.
Fig.II- 188: Filtering Rules page
Allowed IPs
Allowed IP List
allows trusted hosts to reach your network and
vice versa. It is an exception to other rules and only all services may
be allowed for a single host.
Fig.II- 189: Filtering Rules page
The table displayed on the bottom of this page shows the filters selected above, specified by their State (enabled or disabled), the selected Service, the set
Action (allowed or blocked), the IP addresses the filters apply to (if Restricted) and the destination of port forwarding (Redirect to, in case of Incoming
Traffic/Port Forwarding). With the exception of View All, the table offers the following functional buttons:
• Enable is used to enable the rule. If no records are selected the error message “No record(s) selected” will appear.
• Disable is used to disable the rule. If no records are selected the error message “No record(s) selected” will appear.
• Add opens a filter specific page where new rules may be defined by a Service, an Action, a Restriction to certain IP address(es) or IP groups, and if
adding a rule for Incoming Traffic/Port Forwarding, the destination IP address for Forwarding.
The page to add a rule for Incoming Traffic/Port Forwarding offers the following input options:
Service includes a list of possible services to be configured. All custom services also will be displayed in this list.
Action includes possible actions to setup the rule.
Forward to IP requires the destination IP address where traffic should be transferred to if it comes from the restricted host. The IP address defined in this
field will be ignored for blocked action of the Incoming Traffic/Port Forwarding rule.
To Next Page
Loading...
General
