QX50/QX200/QX2000; (SW Version 6.0.x) 117
QX50/QX200/QX2000 Manual II: Administrator’s Guide
Dial Timeout
The Dial Timeout Settings page is used to adjust the dialing timeout setting.
Routing Dial Timeout
setting specifies a period of time after
the last dialed digit that the system identifies as a completion of
dialing. If the user does not press any key within the specified
timeout, the system assumes that the dialing is complete and starts
calling the dialed number. Only predefined values included in the
drop-down list can be used for this setting.
The Routing Dial Timeout setting will also be applied to all the
supported IP phones that are auto-configured with the QX IP PBX
and provide the possibility of changing this setting through the
auto-configuration file. The modified value of the setting will take
effect after rebooting the IP phones.
Fig.II- 175: Dial Plan Settings page
Call Quality Notification
From the Configure Call Quality Event Notification page you may configure event notification policy when the call quality is lower than the allowed
level.
Notify
checkbox, which enables the call
quality monitoring mechanism for the corresponding event
notifications, and a Call Quality less than drop down list where the
least satisfactory call quality should be selected. When a call with the
quality less than the level selected here is registered on the QX IP
PBX, an event notification will appear. When the Notify checkbox is
disabled, no Call Quality events will occur on the QX IP PBX.
Please Note: The ways of notification for the Call Quality events
should be configured from the
Events page.
Fig.II- 176: Configure Call Quality Event Notification page
To Next Page
Loading...
General
