120 Upgrade and Maintenance Manual TX140 S1
Basic software procedures
5.2.17.1 After replacing / upgrading LAN controllers
Please note when re-using a replaced LAN controller:
Ê Confirm with the customer whether the LAN controller you have replaced
has been used as part of a LAN teaming configuration.
Ê If LAN teaming has been active, you will need to restore the configuration
using the LAN driver utility after replacing the LAN controller.
Ensure that the controllers have been assigned as primary or secondary
according to your requirements.
I For details, refer to the relevant LAN driver manual.
5.2.17.2 After replacing the system board
Ê Confirm with the customer whether the onboard LAN controller you have
replaced has been used as part of a LAN teaming configuration.
Ê If LAN teaming has been active, you will need to restore the configuration
using the LAN driver utility after replacing the system board.
I For details, refer to the relevant LAN driver manual.
5.2.18 Switching off the ID indicator
Press the ID button on the front panel or use ServerView Operations Manager
to switch off the ID indicator after the maintenance task has been concluded
successfully.
I For further information, refer to section "Locating the defective server" on
page 54 or to the "ServerView Suite Local Service Concept (LSC)"
manual available from the ServerView Suite DVD 2 supplied with your
PRIMERGY server or online at http://manuals.ts.fujitsu.com (EMEA
market) or http://jp.fujitsu.com/platform/server/primergy/manual/ (Japanese
market).
Using the ID button on the front panel
Ê Press the ID button on the front panel to switch off the ID indicators.
To Next Page
Loading...
Need help?
General