172 Upgrade and Maintenance Manual TX140 S1
Hard disk drives / solid state drives
Ê Locate the defective HDD / SSD module as described in section "Local
diagnostic indicators on the front" on page 57.
Only applicable for removing intact HDD / SSD modules:
Ê Before removing a non-defective HDD / SSD module, put the drive into
"Offline" mode using your RAID configuration software.
7.2.4.3 Removing a 2.5-inch HDD / SSD module
Ê Remove the HDD / SSD module to be replaced from the server as described
in section "Removing a 2.5-inch HDD / SSD module" on page 168.
7.2.4.4 Installing a 2.5-inch HDD / SSD module
Ê Install the new HDD / SSD module into the empty drive bay as described in
section "Installing 2.5-inch HDD / SSD modules" on page 163.
7.2.4.5 Concluding steps
Perform the following procedures to complete the task:
Ê When working on a tower server, close the HDD bay cover as described in
section "Installing the HDD bay cover" on page 84.
Ê Please observe the notes on RAID rebuild in section "Performing a RAID
array rebuild" on page 117.
Ê If applicable, close the rack door as described in section "Closing the rack
door" on page 92.
To Next Page
Loading...
Need help?
General