96 Upgrade and Maintenance Manual TX140 S1
Basic software procedures
5.1.3 Removing backup and optical disk media
Ê Ask the system administrator to eject all remaining backup or optical media
from the backup or optical disk drive before removing it from the server.
Ê If the backup media cannot be ejected by conventional means, and it is
mandatory that the cartridge be removed prior to returning the drive for
repair or disposing it, a manual tape extraction needs to be performed.
For further information on "forcible" tape ejection, please refer to the "Tape
Facts" guide available to Fujitsu service partners from the following https
address:
https://partners.ts.fujitsu.com/com/service/ps/Servers/PRIMERGY/Pages/
TapeFacts.aspx
For the Japanese market, please contact Fujitsu support, if "forcible" tape
ejection is necessary.
I Fujitsu does not assume responsibility for any damage to the tape
drive, the data cartridge / tape or for the loss of any data resulting
from manual tape extraction procedures.
5.1.4 Verifying and configuring the backup software
solution
I This task only applies to the Japanese market.
Depending on the backup software solution, it may be necessary to disable or
delete the backup drive from the backup software drive list before starting the
maintenance task.
This is the case for the following backup software solution:
– BackupExec
I Procedures may differ depending on the backup software. For details,
refer to the dedicated documentation provided separately.
Further information on suitable backup software solutions and related
documentation is available to Fujitsu service partners from the Fujitsu
Extranet pages.
To Next Page
Loading...
Need help?
General