TX140 S1 Upgrade and Maintenance Manual 409
Front panel and external connectors
Ê Shut down the server as described in section "Shutting down the server" on
page 61.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section "Disconnecting power cords" on page 63.
Ê When working on a rack-mounted server, extend it out of the rack as
described in section "Extending the server out of the rack" on page 65.
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 66.
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section "Removing the top cover"
on page 67 (rack server) or "Removing the side cover" on page 71 (tower
server).
Ê Pull out the ID card and open the front cover as described in section
"Removing the rack front cover" on page 69 (rack server) or "Removing the
front cover" on page 74 (tower server).
Ê Remove the fan module as described in section "Removing the fan module"
on page 208.
13.2.3.3 Removing the front panel module
Ê Remove the front panel module as described in section "Removing the front
LAN board" on page 400.
13.2.3.4 Removing the front LAN connector
Ê Remove the defective front LAN connector as described in section
"Removing the front LAN connector" on page 403.
13.2.3.5 Installing the new front LAN connector
Ê Install the new front LAN connector as described in section "Installing the
front LAN connector" on page 389.
13.2.3.6 Re-assembling the front panel module
Ê Re-assemble the front panel module as described in section "Re-
assembling the front panel module" on page 390.
To Next Page
Loading...
Need help?
General