Husqvarna TE 250 Workshop Manual

P.4 Part. N. 8000 B0148 (02-2008)
HYDRAULIC CONTROL CLUTCH
Discharge of hydraulic system fluid
Connect a small plastic hose to the discharge valve and unscrew it by one or two
turns. Remove the reservoir cover and the diaphragm and act release control
lever until all fluid is discharged.
Overhaul of the control pump for clutch release
Drain the system, detach the pump from the L.H. side of the handlebar and
disassemble the pump completely. Replace all gaskets, re-assemble the pump
and assemble it again on the handlebar. Connect the hose and pour new fluid
from the tank; bleed the system as shown on page P.5.

Husqvarna TE 250 Specifications

General

Displacement	249 cc
Transmission	6-speed
Cooling System	Liquid
Starter	Electric
Front Suspension	WP XPLOR 48
Front Brake	Disc brake
Rear Brake	Disc brake
Bore x Stroke	66.4 mm x 72 mm
Engine Type	2-Stroke