CHAPTER 16
Installing the Mounting Hardware
IN THIS CHAPTER
Installing the Mounting Hardware for the SRX3600 Services Gateway | 109
Installing the Mounting Hardware for the SRX3600 Services Gateway
The specific mounting hardware used depends on the type of rack being utilized. Use the appropriate
procedure steps to install the mounting hardware for your situation.
To install the mounting hardware:
1. Locate the rack mount brackets in the accessory kit.
2. Use the screws provided to secure the rack mount brackets to the sides of the chassis:
•
For a two-post rack, mount the brackets at the mid-mount holes, as shown in Figure 40 on page 110.
WARNING: When you install the services gateway in a two-post rack, you must
attach the mounting brackets at the middle of in Figure 40 on page 110. Do not
attempt to install the services gateway in a two-post rack with the mounting brackets
attached at the front of the chassis. Such an installation might overstress either the
brackets or the rack, causing the chassis to fall and inflict injury.
109
To Next Page
Loading...
Need help?
General
