CHAPTER 23
Performing the Initial Configuration
IN THIS CHAPTER
SRX3600 Services Gateway Software Configuration Overview | 153
Performing Initial Software Configuration on the SRX3600 Services Gateway | 154
Performing Initial Software Configuration Using J-Web | 160
SRX3600 Services Gateway Software Configuration Overview
The services gateway is shipped with the Junos operating system (Junos OS) preinstalled and ready to be
configured when the services gateway is powered on. There are three copies of the software: one on a
CompactFlash card (if installed) in the Routing Engine, one on the hard disk in the Routing Engine, and one
on a USB flash drive that can be inserted into the slot in the Routing Engine faceplate.
When the services gateway boots, it first attempts to start the image on the USB flash drive. If a USB flash
drive is not inserted into the Routing Engine or the attempt otherwise fails, the services gateway next tries
the CompactFlash card (if installed), and finally the hard disk.
You configure the services gateway by issuing Junos OS command-line interface (CLI) commands, either
on a console device attached to the RE CONSOLE 0 port on the SFB, or over a Telnet connection to a
network connected to the RE ETHERNET 0 port on the SFB.
Gather the following information before configuring the services gateway:
•
Name the services gateway will use on the network
•
Domain name the services gateway will use
•
IP address and prefix length information for the Ethernet interface
•
IP address of a default router
•
IP address of a DNS server
•
Password for the root user
153
To Next Page
Loading...
Need help?
General
