4. Use the screws to attach the left and right brackets to the rack.
5. Visually inspect the alignment of the chassis. If the chassis is installed properly in the rack, all the
mounting screws on one side of the rack should be aligned with the mounting screws on the opposite
side and the chassis should be level.
RELATED DOCUMENTATION
Required Tools for Installing the SRX3600 Services Gateway Without a Mechanical Lift | 119
Removing Components from the Chassis for Manual Lifting of the SRX3600 Services Gateway | 120
Reinstalling Components in the SRX3600 Services Gateway Chassis | 123
Reinstalling Components in the SRX3600 Services Gateway Chassis
1. Slide each component into the chassis evenly so that it does not become stuck or damaged.
2. Tighten the latching levers and captive screws for each component as appropriate.
NOTE: Make sure that all empty slots are covered with blank panels before operating the services
gateway.
RELATED DOCUMENTATION
Required Tools for Installing the SRX3600 Services Gateway Without a Mechanical Lift | 119
Removing Components from the Chassis for Manual Lifting of the SRX3600 Services Gateway | 120
Lifting the SRX3600 Services Gateway Chassis into the Rack | 122
123
To Next Page
Loading...
Need help?
General
