To Next Page

To Previous Page

CHAPTER 9

Cabinet Requirements

IN THIS CHAPTER

SRX3600 Services Gateway Cabinet Size and Clearance Requirements | 71

SRX3600 Services Gateway Cabinet Airflow Requirements | 72

SRX3600 Services Gateway Cabinet Size and Clearance Requirements

The minimum size cabinet that can accommodate the services gateway is 27.5 in. (69.8 cm) wide and 31.5

in. (80.0 cm) deep. The cabinet must allow at least 5 in. (13 cm) of clearance on each side of the chassis

to allow for cooling air to flow through the vents on each side of the device. A cabinet larger than the

minimum requirement provides better airflow and reduces the chance of overheating.

Allow at least 3 in. (7.6 cm) of vertical clearance between the top and bottom of the services gateway and

other devices in the cabinet.

The minimum front and rear clearance requirements depend on the mounting configuration you choose.

The minimum total clearance inside the cabinet is 30.7 in. (78 cm) between the inside of the front door

and the inside of the rear door.

The device has not been tested for NEBS and ETSI compliance when mounted inside an enclosed cabinet.

NEBS certification only applies if the device is mounted in a two-post or four-post rack.

Juniper SRX3600 Hardware Guide

Other manuals for Juniper SRX3600