9. UTILITY MODE Field Service Ver. 2.0 Jun. 2010
76
bizhub 164
ADJUSTMENT / SETTING
B. TYPE
(1) Use
•To set the media type loaded in the bypass tray.
(2) Procedure
•The default setting is PLAIN.
“PLAIN”/PLAIN-R/CARD1/CARD1-R/CARD2/CARD2-R/
RECYCLE/RECYCLE-R/SPECIAL
9.6.4 PRINT PRIORITY
A. Use
•Specify whether to give priority to print jobs when the machine receives a print job while
printing copies.
COPY : The copy operation is given priority for 30 seconds after printing copies.
If no operation is performed for 30 seconds after printing copies or last copy
operation is finished, execute a print job.
PRINT : As print jobs are given priority, execute a print job immediately after printing
copies.
B. Procedure
•The default setting is COPY.
“COPY”/PRINT
9.6.5 CRISSCROSS MODE
A. Use
•Specify whether or not copies are fed out in an alternating crisscross pattern when the
crisscross output conditions are met.
B. Procedure
•The default setting is OFF.
ON/“OFF”
9.7 COPY SETTING
9.7.1 QUALITY PRIORITY
A. Use
•To set the priority image quality mode that is selected when the power switch is turned
ON or the Back/Stop/Reset key is pressed.
TEXT/PHOTO : Select this option when the original consists of text and photos.
The edge of the text is reproduced sharply, while photos are repro-
duced as a smooth image.
TEXT : Select this option when the original consists of text only.
The edge of the text is reproduced sharply.
PHOTO : Select this option when the original consists of photos only.
Photos are reproduced as a smooth image.
B. Procedure
•The default setting is TEXT/PHOTO.
“TEXT/PHOTO”/TEXT/PHOTO
To Next Page
Loading...
Need help?
General
