Konica Minolta BIZHUB 164 Service Manual

11. SERVICE MODE Field Service Ver. 2.0 Jun. 2010
92
bizhub 164
ADJUSTMENT / SETTING
11.3.20 GDI TIMEOUT
A. Use
•To specify the time for timeout when data from PC is interrupted during GDI printing.
B. Procedure
•The default setting is 60 sec.
5 sec/10 sec/20 sec/30 sec/40 sec/50 sec/“60 sec”
11.3.21 ERASER INSTALL
•Not used.
11.3.22 SUCTION FAN
A. Use
•To specify the length of time from when a print cycle is completed and until when the suc-
tion fan motor stops rotating.
•Used when image failure (while line etc.) occurs due to residual ozone that remains
around the drum.
B. Procedure
•The default setting is 2 sec.
“2 sec”/20 sec/ 60 sec/600 sec
NOTE
•Even when 20 sec. or more is selected in this setting, a higher priority is given to
the shift to sleep mode.
11.3.23 LANGUAGE GROUP
A. Use
•To select the language group applied to the firmware.
•To rewrite the firmware so that it can be used for a different marketing area.
B. Procedure
•The default setting varies depending on the marketing area.
TYPE 1/TYPE 2/TYPE 5/TYPE 6/TYPE7
•The new setting takes effect after the power switch is turned OFF/ON.

Konica Minolta BIZHUB 164 Specifications

General

Print Technology	Laser
Print Speed	16 ppm
Print Resolution	600 x 600 dpi
Copy Speed	16 cpm
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Paper Capacity	250 sheets
Interface	USB 2.0
Warm-up Time	29 seconds
Paper Input Capacity	250 sheets
Memory	32 MB
Type	Monochrome
Maximum Paper Size	A3
Duplex Printing	Manual
Network Connectivity	No
USB Connectivity	Yes
Paper Size	A5
Fax Resolution	Not applicable