Konica Minolta BIZHUB 164 Service Manual

5. OTHER MAINTENANCE ITEMS Field Service Ver. 2.0 Jun. 2010
30
bizhub 164
MAINTENANCE
F. Precautions during setup or transportation
•Whenever mounting an option on the machine, be attentive to the motion of the
fellow worker of the joint work.
The fellow worker may be injured with his or her finger or hand pinched between
the machine and the option.
•When mounting an option on the machine, be careful about the clearance between
the machine and the option.
You may be injured with your finger or hand pinched between the machine and the
option.
•Do not leave the machine unattended during transportation, installation, and
inspection of the machine. If it is to be unavoidably left unattended, face protru-
sions toward the wall or take other necessary risk reducing action.
The user may stumble over a protrusion of the machine or be caught by a cable,
falling to the floor or being injured.
5.1.1 PH unit
A. Reason for prohibition
•The laser runs inside the PH unit. Opening the cover may cause dust to enter and inter-
rupt the laser. Do no remove any screw which may disassemble the PH unit.
5.1.2 Fusing unit
A. Reason for prohibition
•Inner part of the fusing unit and the position of the fusing roller are adjusted prior to ship-
ping. Do not remove any screw which may disassemble the fusing unit.

Konica Minolta BIZHUB 164 Specifications

General

Print Technology	Laser
Print Speed	16 ppm
Print Resolution	600 x 600 dpi
Copy Speed	16 cpm
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Paper Capacity	250 sheets
Interface	USB 2.0
Warm-up Time	29 seconds
Paper Input Capacity	250 sheets
Memory	32 MB
Type	Monochrome
Maximum Paper Size	A3
Duplex Printing	Manual
Network Connectivity	No
USB Connectivity	Yes
Paper Size	A5
Fax Resolution	Not applicable