Konica Minolta BIZHUB 164 Service Manual

11. SERVICE MODE Field Service Ver. 2.0 Jun. 2010
88
bizhub 164
ADJUSTMENT / SETTING
11.3.11 FUSER TEMP. (PLAIN)
A. Use
•To set the temperature of the fusing roller for each type of paper, thereby making up for
fusing performance that changes with the operating environment or type of paper.
•Used when fusing failure occurs.
•Used when the type of paper is changed.
B. Procedure
•The default setting is 0.
-1 to +4
NOTE
•If +2, +3, or +4 is selected, the productivity decreases due to the paper feed inter-
val increased under the PPM control.
<Temperature table for adjusting fusing temperature for plain/recycle paper>
11.3.12 FUSER TEMP. (CARD1)
11.3.13 FUSER TEMP. (CARD2)
A. Use
•To set the temperature of the fusing roller for each type of paper, thereby making up for
fusing performance that changes with the operating environment or type of paper.
•Used when fusing failure occurs.
•Used when the type of paper is changed.
B. Procedure
•The default setting is 0.
-1 to +4
<Temperature table for adjusting fusing temperature for card 1/card 2>
Setting value
Difference from the target temperature determined by
the fusing temperature control
+4 +20 °C
+3 +15 °C
+2 +10 °C
+1 +5 °C
0 (default value) 0 °C
-1 -10 °C
Setting value
Difference from the target temperature determined by
the fusing temperature control
4+20 °C
3+15 °C
2+10 °C
1+5 °C
0 (default value) 0 °C
-1 -10 °C

Konica Minolta BIZHUB 164 Specifications

General

Print Technology	Laser
Print Speed	16 ppm
Print Resolution	600 x 600 dpi
Copy Speed	16 cpm
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Paper Capacity	250 sheets
Interface	USB 2.0
Warm-up Time	29 seconds
Paper Input Capacity	250 sheets
Memory	32 MB
Type	Monochrome
Maximum Paper Size	A3
Duplex Printing	Manual
Network Connectivity	No
USB Connectivity	Yes
Paper Size	A5
Fax Resolution	Not applicable