Konica Minolta BIZHUB 164 Service Manual

Field Service Ver. 2.0 Jun. 2010 9. UTILITY MODE
77
bizhub 164ADJUSTMENT / SETTING
9.7.2 DENSITY PRIORITY
A. Use
•To set the priority density that is selected when the power switch is turned ON or the
Back/Stop/Reset key is pressed.
AUTO : The density level is automatically adjusted.
MANUAL : The density level is manually adjusted.
B. Procedure
•The default setting is AUTO.
“AUTO”/MANUAL
9.7.3 DENSITY LEVEL
A. AUTO
(1) Use
•To set the density level when the auto density is selected.
(2) Procedure
•The default setting is displayed with .
LIGHT  DARK
B. MANUAL
(1) Use
•To set the density level when the manual density is selected.
(2) Procedure
•The default setting is displayed with .
LIGHT  DARK
9.7.4 ERASE SETTING
A. Use
•Specify the erase width between 5 mm and 20 mm (in 1 mm increments) when making
copies with [LEFT ERASE], [UPPER ERASE] or [FRAME ERASE] selected for the
[ERASE] setting.
LEFT : Erases the left side of the original.
UPPER : Erases the upper side of the original.
FRAME : Erases the frame around the original.
B. Procedure
1. Select the erase position.
•The default setting is LEFT.
“LEFT”/UPPER/FRAME
2. Set the erase width.
•The default setting is 10 mm.
5 to 20 mm (1 step: 1 mm)

Konica Minolta BIZHUB 164 Specifications

General

Print Technology	Laser
Print Speed	16 ppm
Print Resolution	600 x 600 dpi
Copy Speed	16 cpm
Copy Resolution	600 x 600 dpi
Scan Resolution	600 x 600 dpi
Paper Capacity	250 sheets
Interface	USB 2.0
Warm-up Time	29 seconds
Paper Input Capacity	250 sheets
Memory	32 MB
Type	Monochrome
Maximum Paper Size	A3
Duplex Printing	Manual
Network Connectivity	No
USB Connectivity	Yes
Paper Size	A5
Fax Resolution	Not applicable