SAFETY FEATURES
WARNING
T
o avoid personal injury or death:
• Place the machine on a firm, flat and level
surface
• Before starting the engine, make sure that no
one is near the machine.
HOW TO USE THE
EMERGENCY EXIT
This window is equipped with latches. If you should
become
trapped in the cab, you can open the rear
window to get out.
1. Turn both latches clockwise until they disengage
from the window frame.
2. Push the rear window out of the rear of the operator
cab.
3. Exit through the rear of the operator cab.
(1) Window (2) Latch
OPC FUNCTION
OPC function is used to detect the operator sitting on
the
seat and to signal the hydraulic system that it can
be unlocked.
When the operator sits on the operator's seat and lower
the armrests, the hydraulic system can be unlocked.
HOW TO USE AND CHECK THE
FUNCTION OF THE ARMREST
1. Sit in the operator's seat.
2.
Fasten the seat belt.
3. Start the engine.
4.
Push down both armrests.
5. Push on the hydraulic-unlock-switch, and make
sure that the hydraulic-lock-indicator on the
instrument panel goes out.
6. Move the right-control-lever (front-operating-lever)
slowly, and make sure that the lift arms and bucket
move slowly.
7. Raise the left armrest, and make sure that the
hydraulic-lock-indicator on the instrument panel
lights up.
8. Move the right-control-lever (front-operating-lever),
and make sure that the lift arms and bucket do not
operate.
9. Push down the left armrest.
10. Push on the hydraulic-unlock-switch, and make
sure that the hydraulic-lock-indicator on the
instrument panel goes out.
11. Raise the right armrest, and make sure that the
hydraulic-lock-indicator on the instrument panel
lights up.
12. Move the right-control-lever (front-operating-lever),
and make sure that the lift arms and bucket do not
operate.
When checking the function of the armrest, also check
the OPC function.
(See
HOW TO USE AND CHECK THE SEAT
FUNCTION on page 106)
HOW TO USE AND CHECK THE
SEA
T FUNCTION
1. Sit in the operator's seat.
2.
Start the engine.
3. Push down both the armrests.
4. Push on the hydraulic-unlock-switch, and make
sure that the hydraulic-lock-indicator on the
instrument panel goes out.
HOW TO CHECK THE BACK-UP
ALARM
1. Start the engine.
2. If
clear, engage hydraulics and start to reverse.
Alarms should sound. If not, check by your
KUBOTA dealer.
 SAFETY FEATURES HOW TO USE THE EMERGENCY EXIT
To Next Page
Loading...
Need help?
General
