MAINTENANCE
WARNING
T
o avoid personal injury or death:
• Before performing maintenance on the
machine, place the machine on a firm, flat, and
level surface, lower the lift arms slowly to the
ground, and stop the engine.
• When performing maintenance on the machine,
do not allow any persons within the cab.
• To prevent the machine from being damaged,
set the washing nozzle to spreading water, and
keep the distance 2 m away from the machine to
clean it. When the water is directed at a pin
point area, or when the machine is washed from
too close a position with a high pressure flow:
– The cover of the wiring may be damaged or
the wiring may be cut off, causing fire.
– The hydraulic hose may be damaged,
causing a high pressure oil blow out.
This may cause injury.
IMPORTANT :
• To prevent the hydraulic oil tank from being
damaged, do not apply the vacuum pressure
below -10 kPa.
• If the machine is not washed as specified, the
following peel-off, damage or malfunction may
result.
Examples:
– The stickers or labels may peel away.
– The electronic components, engine
compartment, cab and others may get wet
inside and adversely affected.
– The tracks, oil seals and other rubber-based
components, the decorative covers and
other plastic-based components, and the
windows and other glass-based
components may get damaged.
– The paint, coating, and plating may peel
away.
No high pressure-washer
(A) High pressure (B) Low pressure
No pressure-washer at short range
(A) Less than 2 m (B) 2 m or more
Whether the machine is properly lubricated and
maintained
directly determines the trouble frequency
and service life of the machine. Periodically check and
maintain your machine, and you will find in the long run
that the jobs can be finished earlier and more
economically.
IMPORTANT :
• Do not remove the plate (step). Once this plate
is removed, the airtightness of the cab will
degrade.
 MAINTENANCE
To Next Page
Loading...
Need help?
General
