2GN/2GP/2GR-7
1-3-82
U917
Setting backup data reading/writing
Description
Retrieves the backup data to a USB memory from the machine; or writes the data from the USB memory to
the machine.
Purpose
To store and write data when replacing the HDD.
Supplement
This maintenance item is supported with the firmware version later than below.
MAIN: Ver. 008.027
MMI: Ver. 014.025
ENGINE: Ver. 009.001
Method
1. Insert USB memory in USB memory slot.
2. Enter the maintenance item.
3. Press the start key.
4. Select [Export] or [Import].
5. Select the item.
*: Since data are dependent with each other, data other than those assigned are also retrieved or written
in.
6. Press the start key. Starts reading or writing.
Pulls USB memory out after the progress ratio is displayed [100].
An error code is displayed in case of an error.
7. Press the stop key.
8. Turn the main power switch off and on when selecting [Import].
Maintenance
item No.
Description
Display Description
Export Retrieving from the machine to a USB memory
Import Writing data from the USB memory to the machine
Display Description Description
Address Book Address book -
Job Accnt. Job accounting -
FAX Forward FAX transfer information Job accounting, user management and document
box information
One Touch Information on one-touch Address book
User User managements Job accounting
Shortcut Shortcut information Job accountings, user managements and docu-
ment box information
Document Box Document box information Job accountings and user managements
Program Program information Job accountings, user managements and docu-
ment box information
To Next Page
Loading...
Need help?
General
Weight and Dimensions
