Toyota Orderpicker Model 7BPUE15 Service Manual
Section 2. Safety
Welding
Safety
Flame cutting or welding on painted
surfaces may produce potentially
harmful fumes, smoke and vapors. Prior
to performing flame cutting or welding
operations, it
is
recommended that the
coating be removed in the vicinity where
the
operation(s) will be performed.
Welding Safety
Disconnect the battery before you
attempt to inspect, service or repair the
lift truck. Discharge residual charge in
the traction power amplifier by pressing
in the
PC
and
P
contactors at the same
time.
Check for any shorts to the frame as
described on page
5
-
4.
If any shorts are
detected, remove them before you proceed
with the welding operation.
Coating removal may be by mechanical
methods, chemical methods or a
combination of methods. Flame cutting
and/or welding operations should be
carried out only in well ventilated areas
using local exhaust if necessary.
Clean the area to be welded.
Protect all truck components from heat,
weld spatter and debris.
Attach the ground cable as close to the
weld area as possible.
Do not perform
any
welding operation
near the electrical components.
If welding must be done near the battery
compartment, remove the battery.
When you are finished welding, perform all
ground tests and electrical inspections
before the vehicle is operated.
Before working on this truck, make sure that:
Fire protection equipment is nearby.
You know where the nearest eyewash
station is.
00700
-
CL222
-
05,
1
5 March 2005
To Next Page
Loading...
Need help?
General
