Section 5. Troubleshooting Toyota Orderpicker Model
7BPUE
15 Service Manual
Programmable Maintenance Tool
Programming
You can change certain parameters using the
PMT. See Table 5
-
7. All changes occur in
"
real
time
"
; the parameters can be changed while the
truck is in operation.
1. Turn the key switch OFF and disconnect
the battery connector.
2.
Remove the tractor cover.
3.
Connect the PMT to the traction power
amplifier.
4.
Connect the battery and turn the key
switch ON.
5. Press the program key to enter the
Program mode.
6.
Press either scroll display key until the
parameter you want is the top line of the
display. See Table 5
-
7.
Table
5-7.
Traction Power Amplifier Parameters
7. Press either change value key until the
setting you want is displayed. The
parameter is now set at the value you
selected.
8.
If the display stops changing and you want
to go further, press the more info key. If
the display shows
"
Min. Limit
"
or
"
Max
Limit,
"
you have reached the factory set
limit for that parameter.
N
O
T
E
:
The parameter may be dependent on
another parameter. If so, the display will
show this information. Changing the
related parameter may allow you to
change the setting further.
See
"
Definitions
"
on page 5
-
17.
neutral
with
the deadman switches closed.
M3 RESTRAINT
With neutral braking set at
0%,
the truck coasts
to
a
stop when the throttle is in neutral
(released). There is no plugging force applied.
When set to
loo%,
the power amplifier applies
ing force when the throttle is in neutral
00700
-
CL222
-
05,
1
5
March 2005
To Next Page
Loading...
Need help?
General
