Xerox Phaser 6180MFP Service Manual

3-136 Phaser 6180MFP Multifunction Printer Service Manual
Error Messages and Codes
Motor Error (Tray 2)
The Tray 2 Motor has failed. The following troubleshooting procedure applies
to this error.
Applicable Chain Link
■ Chain Link 077-343: Tray 2 Motor Error (IOT Motor Failure)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Feeder Unit Kit, PL3.2.1
■ Feed Drive Assembly, PL8.1.7
■ MCU Board, PL9.2.13
■ Right Side Harness, PL10.1.12
■ “Map 1 - Electrical and Drive” on
page 10-10
■ “Map 4 - LVPS and MCU Board” on
page 10-13
■ “Tray 1 (MPT) and Registration” on
page 10-26
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the Rubber Registration
Roller for rotation.
2.Does the Roller rotate smoothly?
Go to step 2. Replace the
Feeder Unit
(page 8-47).
2 1.Check the wiring harness
connectors P/J25 and P/J251
between the MCU Board and the
Drive Assembly.
2.Are the connectors securely
connected?
Go to step 3. Reconnect the
connectors.
Go to step 3.
3 1.Perform Tray 2 Motor test
(page 4-56): Service Mode >
Printer Diag > Engine Diag > Motor
Test > Tray 2 Motor. During the test,
close the Front Cover.
2.Does the Motor operate properly?
Replace the
MCU Board
(page 8-88).
Go to step 4.
4 1.Check the Feed Drive Assembly for
correct installation.
2.Is the Feed Drive Assembly correctly
installed?
Go to step 5. Reseat the Feed
Drive Assembly
(page 8-78).
Go to step 5.

Xerox Phaser 6180MFP Specifications

General

Brand	Xerox
Model	Phaser 6180MFP
Category	All in One Printer
Language	English