Xerox Phaser 6180MFP Service Manual

1-28 Phaser 6180MFP Multifunction Printer Service Manual
General Information
Warm-Up Time
Warm-up Time is defined as the time when the printer changes from Power-
On to Standby mode.
■ Standard Configuration: 30 seconds or less
■ Environmental Temperature: 22° C (72° F)
■ Humidity: 55% RH
First Print Output Time
First Print Output Time (FPOT) is defined as the time from when the engine
receives a Start signal in Ready state, until a single page is printed and
delivered to the output tray.
The following conditions are applied:
■ The Controller does not keep the print engine waiting.
■ The printer is at Ready mode (Laser Unit Motor Off, Fuser Ready).
■ Paper is A size Short-Edge Feed (SEF).
■ Process control time is not included.
First Copy Output Time
First Copy Output Time (FCOT) is defined as the time slot when the Start
button is pressed until the trail edge of the first copied media passes the
printer Exit Roller.
The following conditions are applied:
■ The Controller does not keep the print engine waiting.
■ The printer is at Ready mode (Laser Unit Motor Off, Fuser Ready).
■ Paper is A size Short-Edge Feed (SEF).
■ Document is on the document glass (Document setting: Platen mode).
■ Media: Media feed from the standard media tray.
Mode FPOT (sec.)
Color As fast as 10.0
Mono As fast as 10.0
Mode FCOT (sec.)
Color As fast as 11.1
Mono As fast as 20.0

Xerox Phaser 6180MFP Specifications

General

Brand	Xerox
Model	Phaser 6180MFP
Category	All in One Printer
Language	English