Xerox Phaser 6180MFP - Incorrect Password

3-208 Phaser 6180MFP Multifunction Printer Service Manual
Error Messages and Codes
Incorrect Password
The DFAX password does not match with the Fax/Scan Lock password. The
following troubleshooting procedure applies to this error.
Applicable Chain Link
■ Chain Link 033-517: Incorrect Password (DFAX Password Error)
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Scanner Controller Board, PL9.1.1
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the password setting: System
> Admin Menu > Secure Settings >
Scan/Fax Lock.
2.Is the password correct?
Go to step 2. Set the
password.
2 1.Check the Scanner Controller Board
for correct installation. Reseat the
Scanner Controller Board
(page 8-99).
2.Does the error still occur when the
printer is turned On?
Replace the
Scanner
Controller Board
(page 8-99).
Complete.