6-4 Phaser 6180MFP Multifunction Printer Service Manual
Adjustments and Calibrations
Manual Adjustment
Use the adjustment information in the following table to perform Color
Registration procedure.
Caution
After printing the Color Registration Correction Chart, DO NOT turn Off
the printer until the printer motor has stopped running.
1. From the Control Panel, press the System button.
2. Press the Up Arrow or Down Arrow button to find Admin Menu. Press
the OK button.
3. Press the Up Arrow or Down Arrow button to find Maintenance. Press
the OK button.
4. Press the Up Arrow or Down Arrow button to find Adjust ColorRegi.
Press the OK button.
5. Press the Up Arrow or Down Arrow button to find Color Regi. Press the
OK button.
6. Select Yellow, Magenta, or Cyan and press the OK button
7. Use the Up Arrow or Down Arrow button to enter the values and press
the OK button to save the data.
8. Repeat steps 6 and 7 to continue adjusting the Color Registration.
9. Press the Exit button to access the Color Regi Chart menu. Select
Color Regi Chart and press the OK button.
10. Press the OK button again to print the Color Regi Chart.
11. The Color Registration adjustment is complete when the straightest Y
(yellow), M (magenta), and C (cyan) lines are next to the “0” line.
o
e
If “0” is not next the straightest lines, determine and adjust the values
again.
Color Registration Adjustment
Color
Range Default
Yellow -9 to +9 0
Magenta -9 to +9 0
Cyan -9 to +9 0
To Next Page
Loading...
Need help?
General
