5-51
PIÑ
N DEL
BALANCEADOR



BALANCER SPROCKET

1.
Loosen:
•
Primary drive gear nut "1"
ASSEMBLY PRIMARY BALANCER DRIVEN
GEAR
1.
Assembly:
•
Dowel pin "1"
NOTE:
Place a sheet of leather or a leather "a" between
the primary drive gear anceador bal "2" and led
engranaj primary balancer and "3", and then
loosen the nut
of gear driving primary.
•
Springs "2"
(With the glass ceiling)
NOTE:
Install the pins and springs alternately as shown.

2

3



1
1

to
2
2.
Straighten the lock washer.
3.
Loosen:
•The primary driven gear nut balancer "1"
NOTE:
Place an aluminum plate "a" between the
primary balancer drive gear "2" and the primary
balancer driven gear "3", and then loosen the nut
on the balancer driven gear primary.
2. Assembly:
•
Glass ceiling "1"
•
Primary balancer driven gear "2"
NOTE:
Align the punch mark "a" in the glass ceiling with
the punch mark "b" on the balancer driven gear
primary.

2
to
1


1
b
to
2
MOUNT BALANCER GEARS AND GEAR
3
PRIMARY CONDUCTOR
1.
Install:

INSPECTION PINION BALANCER GEARS AND
GEAR PRIMARY CONDUCTOR
1. Check:
•Primary balancer drive gear
•Primary balancer driven gear
•
Cup stop
•Spring
•
Primary balancer drive gear "1"
•
Lockwasher
New
•
Primary balancer driven gear "2"
•
Primary drive gear
•
Washer "3"
•
Nut primary driven gear
balancer
•
Primary drive gear nut
•
Dowel pin
Cracks / damage / wear
Replace יו.
2.
Check:
•
Primary drive gear
See " INSPECTION
Primary drive gear "On page 5-39.
NOTE:
•Align the punch mark "a" on the primary drive
gear balancer with the punch mark "b" on the
balancer driven gear primary "1".
•Make sure the corners with sharp edges of the
thrust washer "c" stands next
opposite the primary drive gear.
To Next Page
Loading...
Need help?
General
