7-24
FUNCI
N DE
AUT
O-DIAGN
STICO





to
b

c d
c
Fault Code No.
No fault code
Check and repair. See "D ata
TROUBLESHOOTING"
Monitoring the operation of
sensors and actuators in the
diagnostic mode. See
ection "T ableof operation of
sensors" and "actuators
operating table"
Check and repair
See "Table of the
auto-diagnosis"

FAULT CODE TABLE


Fault
Code

Item
Symptom
Can / can
not boot
Can /
can not
drive

15
Throttle Position Sensor
(Open or short)
Throttle position sensor:
open or short circuit detected.
You can

You

16
Throttle Position Sensor
(Attached)
Throttle position sensor is
attached
You can

You

Verification bulb warning light engine trouble
The warning light comes on engine failure for 3 seconds after the main switch is turned to "ON". If the
warning light does not come on in these conditions, the communication cable is disconnected or the LED
warning light may be defective.

to
b



c
d
c



a. Switch to "OFF" b. Switch to
"ON"
c. Warning Light Engine trouble off
d. Warning Light Engine trouble on for 3
seconds

TROUBLESHOOTING METHOD

Motor operation is not normal and the warning
light comes on engine failure.
1.
Check:
•Fault code number

a. Check the fault code displayed on the meter.
b. Identify the flaw in the system with the fault
code.
See "Table of the auto-diagnosis."
c. Identify the likely cause of the failure.
See "Fault Code Table".

2. Check and repair the probable cause of evil
operation.
Turn the ignition switch to "OFF" and return to
"ON", and check for any number of
Fault code is shown.