3-6
MOTOR



CAUTION
Do not alter carburetor adjustments, if engine
performance is good.
If necessary, you must register the existing settings
(# of turns) mixture screw.
To check the configuration of the screw
c. Tighten the locknut.

1
carburetor mixing, follow the
to
CO adjustment procedure "
b

Ensure proper blanking plug fixation

6. Fit:
The engine idle stop screw
5
accelerator "1"


Engine idling R.P.M.
1300 to 1500 RPM

FREE PLAY ADJUSTMENT THROTTLE
CABLE
NOTE:
Before adjusting the free play of the throttle
cable, adjust the engine idle

1. Verify
Clearance "a" throttle cable
OOS
Adjustment




Throttle cable slack
3.0-5.0 mm
NOTE:
If not obtain the specified free play throttle cable
on the side of the carburetor, use the adjusting
nut on the side of the handlebar.
Keep upright handlebars.



Handlebar side
a. Slide back the rubber cover "1" b. Loosen the
locknut "2"
c. Turn the adjusting nut "3" in direction "a" or "b"
until you obtain the specified free play in the
throttle cable

Direction "a"
The free play is increased throttle cable
Direction "b"
The free play is decreased throttle cable

2. Adjustment
b 3
Throttle cable slack
1
to
2
Carburetor Side

a. Loosen the locknut "1" Throttle Cable
b. Turn the adjusting nut "2" in direction "a" or
"b" until you obtain the specified free play in
the throttle cable

Direction "a"
The free play is increased throttle cable
Direction "b"
The free play is decreased throttle cable
d. Tighten the nut
e. Slide the rubber to its original position

WARNING
After adjusting the free play of the throttle cable,
start the engine and turn the handlebars to the right
or left to make sure this does not lead to changes in
engine idle.
To Next Page
Loading...
Need help?
General
