chronological order in which the IED should be commissioned. The relevant
procedures may be followed also during the service and maintenance activities.
The operation manual contains instructions on how to operate the IED once it has been
commissioned. The manual provides instructions for the monitoring, controlling and
setting of the IED. The manual also describes how to identify disturbances and how to
view calculated and measured power grid data to determine the cause of a fault.
The application manual contains application descriptions and setting guidelines
sorted per function. The manual can be used to find out when and for what purpose a
typical protection function can be used. The manual can also provides assistance for
calculating settings.
The technical manual contains application and functionality descriptions and lists
function blocks, logic diagrams, input and output signals, setting parameters and
technical data, sorted per function. The manual can be used as a technical reference
during the engineering phase, installation and commissioning phase, and during
normal service.
The communication protocol manual describes the communication protocols
supported by the IED. The manual concentrates on the vendor-specific
implementations.
The point list manual describes the outlook and properties of the data points specific
to the IED. The manual should be used in conjunction with the corresponding
communication protocol manual.
1.3.2 Document revision history
Document revision/date
History
-/March 2013 First release
A/October 2016 Minor corrections made
1.3.3 Related documents
Documents related to REC650
Identity number
Application manual 1MRK 511 286-UEN
Technical manual 1MRK 511 287-UEN
Commissioning manual 1MRK 511 288-UEN
Product Guide 1MRK 511 289-BEN
Type test certificate 1MRK 511 289-TEN
650 series manuals Identity number
Communication protocol manual, DNP 3.0 1MRK 511 280-UEN
Communication protocol manual, IEC 61850–8–1 1MRK 511 281-UEN
Communication protocol manual, IEC 60870-5-103 1MRK 511 282-UEN
Table continues on next page
1MRK 511 287-UEN A Section 1
Introduction
31
Technical manual