DescriptionParameter
Enables BroadWorks Anywhere feature on an extension.
Perform one of the following:
• In the phone configuration file with XML(cfg.xml), enter a string
in this format:
<Anywhere_Enable_1_ ua="na">Yes</Anywhere_Enable_1_>
• In the phone web page, select Yes, Anywhere is enabled on this
line, and the user can use the phone menu to add multiple locations
to this specific line.
Valid values: Yes|No
Default: Yes
Anywhere Enable
Sync the Block Caller ID Feature with the Phone and the
BroadWords XSI Server
You can sync the Block caller id status on the phone and the Line ID Blocking status on the BroadWorks
XSI server. When you enable the synchronization, the changes that the user makes in the Block caller id
settings also changes the BroadWorks server settings.
You can also configure the parameters in the phone configuration file with XML(cfg.xml) code.
Before you begin
Access the phone administration web page. See Access the Phone Web Interface, on page 104.
Procedure
Step 1 Select Voice > Ext(n).
Step 2 In the XSI Line Service section, set the Block CID Enable parameter. Choose Yes to enable the
synchronization of blocking caller id status with the server using XSI interface. Choose No to use the phone's
local blocking caller id settings.
You can configure this parameter in the phone configuration XML file (cfg.xml) by entering a string in this
format:
<Block_CID_Enable_1_ ua="na">No</Block_CID_Enable_1_>
• When Feature Key Sync is set to Yes, FKS takes precedent over XSI synchronization.
• If XSI host server and credentials are not entered and the CFWD Enable field is set to Yes,
the phone user can't forward calls on the phone.
Note
Options: Yes and No
Default: No
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
202
Cisco IP Phone Configuration
Sync the Block Caller ID Feature with the Phone and the BroadWords XSI Server
To Next Page
Loading...
Need help?
General
