CHAPTER 17
Cisco IP Phone Installation
• Verify the Network Setup, on page 311
• Install the Cisco IP Phone, on page 312
• Configure the Network from the Phone, on page 313
• Set Up Wireless LAN from the Phone, on page 320
• Verify Phone Startup, on page 325
• Configure Internet Connection Type, on page 325
• Configure VLAN Settings, on page 326
• Set Up a Wi-Fi Profile from the Phone, on page 330
• Set Up a Wi-Fi Profile , on page 332
• Delete a Wi-Fi Profile, on page 336
• Change the Order of a Wi-Fi Profile , on page 336
• Scan and Save a Wi-Fi Network, on page 337
• SIP Configuration, on page 339
• NAT Transversal with Phones, on page 384
• Dial Plan, on page 393
• Regional Parameters Configuration, on page 400
• Cisco IP Phone 8800 Series Documentation, on page 416
Verify the Network Setup
For the phone to operate successfully as an endpoint in your network, your network must meet specific
requirements.
Procedure
Step 1 Configure a VoIP Network to meet the following requirements:
• VoIP is configured on your routers and gateways.
Step 2 Set up the network to support one of the following:
• DHCP support
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
311
To Next Page
Loading...
Need help?
General
