Cisco 8861 Guide

Response Status Code Handling Paramters
The following table defines the function and usage of the parameters in the Response Status Code Handling
section under the SIP tab in the phone web interface. It also defines the syntax of the string that is added in
the phone configuration file with XML(cfg.xml) code to configure a parameter.
Table 71: Response Status Code Handling Paramters
DescriptionParameter
This parameter may be set to invoke failover upon
receiving specified response codes.
For example, you can enter numeric values 500 or a
combination of numeric values plus wild cards if
multiple values are possible. For the later, you can
use 5?? to represent all SIP Response messages within
the 500 range. If you want to use multiple ranges, you
can add a comma "," to delimit values of 5?? and 6??
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<Try_Backup_RSC ua="na"/>
• In the phone web page, enter an appropriate
value.
Default: Blank
Try Backup RSC
Interval to wait before the phone retries registration
after failing during the last registration.
For example, you can enter numeric values 500 or a
combination of numeric values plus wild cards if
multiple values are possible. For the later, you can
use 5?? to represent all SIP Response messages within
the 500 range. If you want to use multiple ranges, you
can add a comma "," to delimit values of 5?? and 6??
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<Retry_Reg_RSC ua="na"/>
• In the phone web page, enter an appropriate
value.
Default: Blank
Retry Reg RSC
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
352
Cisco IP Phone Installation
Response Status Code Handling Paramters

Cisco 8861 Specifications

General

Brand	Cisco
Model	8861
Category	IP Phone
Language	English