Cisco 8861 Guide

DescriptionParameter
Sets the default volume for the Bluetooth device.
Perform one of the following:
• In the phone configuration file with XML(cfg.xml), enter a string in this format:
<Bluetooth_Volume ua="rw">9</Bluetooth_Volume>
• In the phone web page, enter a valid value as the Bluetooth volume.
Allowed values: an integer ranging between 0 and 15
Default: 9
Bluetooth Volume
Enables or disables the Electronic HookSwitch (EHS) feature. After EHS is enabled,
the AUX port does not output phone logs.
Perform one of the following:
• In the phone configuration file with XML(cfg.xml), enter a string in this format:
<Ehook_Enable ua="na">Yes</Ehook_Enable>
• In the phone web page, enter a valid value as the EHS volume.
Allowed values: Yes|No
Default: No
Electronic
Hookswitch Control
Configure the Acoustic Settings
You can configure the audio settings for the phone speaker, the handset, and the connected headsets.
You can also configure the parameters in the phone configuration file with XML (cfg.xml) code. To configure
each parameter, see the syntax of the string in Parameters for Acoustic Settings, on page 276.
Before you begin
Access the Phone Web Interface, on page 104.
Procedure
Step 1 Select Voice > User.
Step 2 In the Acoustic Settings area, set the acoustics as described in Parameters for Acoustic Settings, on page 276
Step 3 Click Submit All Changes.
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
275
Cisco IP Phone Configuration
Configure the Acoustic Settings

Cisco 8861 Specifications

General

Brand	Cisco
Model	8861
Category	IP Phone
Language	English