You can also configure the parameter in the configuration file (cfg.xml). The parameter is line-specific. Enter
a string in the following format:
<Extension_2_ ua="na">Disabled</Extension_2_>
Step 4 In the Extended Function field, enter a string in this format:
fnc=xml;url=http://xml.service.url;nme=name
where:
• fnc= prk means function=call park.
• url= http://xml.service.url is the URL for the xml application or directory.
• nme= XXXX is the name displayed on the phone for the xml service. Replace XXXX with a name.
You can also configure the line-specific parameter in the configuration file (cfg.xml). Enter a string in the
following format:
<Extended_Function_2_
ua="na">fnc=xml;url=http://xml.service.url;nme=name</Extended_Function_2_>
Step 5 Click Submit All Changes.
Programmable Softkeys Configuration
Customize Display of the Softkeys
You can customize display of the softkeys on the phone screen during a specific state.
You can also configure the parameters in the phone configuration file with XML (cfg.xml) code. To configure
each parameter, see the syntax of the string in Parameters for Programmable Softkeys, on page 262.
Before you begin
Access the phone administration web page. See Access the Phone Web Interface, on page 104.
Procedure
Step 1 Select Voice > Phone.
Step 2 In the Programmable Softkeys section, edit the softkeys depending on the call state that you want the softkey
to display. For more information, see Parameters for Programmable Softkeys, on page 262 and .
Step 3 Click Submit All Changes.
Parameters for Programmable Softkeys
The following table defines the function and usage of the programmable softkeys parameters in the
Programmable Softkeys section under the Voice > Phone tab in the phone web interface. It also defines the
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
262
Cisco IP Phone Configuration
Programmable Softkeys Configuration
To Next Page
Loading...
Need help?
General
