DescriptionParameter
Interval, in seconds, to allow a reconnect without a
log in after the client disconnects from the server.
After this interval, the client needs to reauthenticate.
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<Login_Invisible
ua="na">Yes</Login_Invisible>
• In the phone web page, select Yes to enable the
feature.
Options: Yes and No
Default: No
Retry Intvl
Configure the Number of Call Appearances Per Line
Phones that support multiple call appearances on a line can be configured to specify the number of calls to
allow on the line.
You can also configure the parameters in the phone configuration file with XML(cfg.xml) code.
Before you begin
Access the phone administration web page. See Access the Phone Web Interface, on page 104.
Procedure
Step 1 Select Voice > Phone.
Step 2 In the Miscellaneous Line Key Settings section, for the Call Appearances Per Line parameter, specify the
number of calls per line to allow.
You can also configure this parameter in the configuration file (cfg.xml) by entering a string in this format:
<Call_Appearances_Per_Line ua="na">2</Call_Appearances_Per_Line>
The allowed values range from 2 to 10. The default value is 2.
Step 3 Click Submit All Changes.
Enable Reverse Name Lookup
Reverse name lookup searches for the name of a number in an incoming, outgoing, conference, or transferred
call. The reverse name lookup acts when the phone cannot find a name using the service provider directory,
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
254
Cisco IP Phone Configuration
Configure the Number of Call Appearances Per Line
To Next Page
Loading...
Need help?
General
