FINAL REDUCTION
12-3
SERVICE INFORMATION
GENERAL
• Refer to final reduction oil inspection and change (page 4-15).
• The final reduction can be serviced with the engine installed in the frame.
• When installing the driveshaft, be sure to use the special tools; position the special tools on the bearing inner race and
pull the driveshaft into the bearing until it is fully seated.
SPECIFICATIONS
TORQUE VALUES
TOOLS
ITEM SPECIFICATIONS
Final reduction oil
capacity
After draining 0.10 liter (0.11 US qt, 0.09 lmp qt)
After disassembly 0.12 liter (0.13 US qt, 0.11 lmp qt)
Recommended final reduction oil Honda "4-stroke motorcycle oil" or an equivalent
API classification: SG or higher (except oils labeled as
energy conserving on the circular API service label)
Viscosity: SAE 10W-30
JASO T 903 standard: MB
Final reduction oil check bolt 13 N·m (1.3 kgf·m, 10 lbf·ft)
Final reduction oil drain bolt 13 N·m (1.3 kgf·m, 10 lbf·ft)
Bearing remover head, 12 mm
07936-1660110
Bearing remover shaft, 12 mm
07936-1660120
Remover weight
07741-0010201
Bearing remover head, 15 mm
07936-KC10200
Bearing remover shaft, 15 mm
07936-KC10100
Driver
07749-0010000
To Next Page
Loading...
Need help?
General